Cleaning and maintenance

低壓配電柜每隔一段時間都需要進行清潔，以確保電氣元件的正常運行。在清潔時，應先切斷電源，用軟刷或干凈的布擦拭配電柜的表面，特別是蓋板、門和插座等易受灰塵和臟物積累的地方。同時，還要檢查配電柜的通風孔是否被堵塞，如果有堵塞，應及時清理，以免影響散熱效果。

The low-voltage distribution cabinet needs to be cleaned at regular intervals to ensure the normal operation of electrical components. When cleaning, the power should be cut off first, and the surface of the distribution cabinet should be wiped with a soft brush or clean cloth, especially in areas prone to dust and dirt accumulation such as covers, doors, and sockets. At the same time, it is also necessary to check whether the ventilation holes of the distribution cabinet are blocked. If there are blockages, they should be cleaned in a timely manner to avoid affecting the heat dissipation effect.

定期檢查

Regular inspection

為了保證低壓配電柜的正常運行，定期檢查是必不可少的。可以選擇每半年或一年進行一次檢查。檢查包括以下幾個方面：

Regular inspections are essential to ensure the normal operation of low-voltage distribution cabinets. You can choose to undergo a comprehensive examination every six months or once a year. The inspection includes the following aspects:

仔細檢查配電柜是否有損壞、破裂或腐蝕的現象，如有，及時更換或維修。

Carefully inspect the distribution cabinet for any damage, breakage, or corrosion, and if so, replace or repair it in a timely manner.

檢查接線端子和插座，確保沒有松動或刺傷現象，必要時重新擰緊或更換。

Check the wiring terminals and sockets to ensure they are not loose or punctured, and tighten or replace them if necessary.

檢查接地線是否完好，確保電氣設備的接地。

Check the integrity of the grounding wire to ensure the safe grounding of electrical equipment.

檢查斷路器、熔斷器和接觸器的工作狀態，如發現異常，應及時更換。

Check the working status of circuit breakers, fuses, and contactors. If any abnormalities are found, they should be replaced in a timely manner.

檢查電流互感器和電壓互感器的工作狀態，確保其準確度和靈敏度。

Check the working status of current transformers and voltage transformers to ensure their accuracy and sensitivity.

維護電氣元件

Maintain electrical components

電氣元件是低壓配電柜的核心部分，需要經常維護和保養。維護電氣元件的具體方法包括：

Electrical components are the core part of low-voltage distribution cabinets and require frequent maintenance and upkeep. The specific methods for maintaining electrical components include:

清潔電氣元件表面的灰塵和臟物，確保其正常工作。

Clean the dust and dirt on the surface of electrical components to ensure their normal operation.

定期檢查電氣元件的工作狀態，如觸點是否干凈，接觸是否良好等。如有異常，應及時更換或修理。

Regularly check the working status of electrical components, such as whether the contacts are clean and in good contact. If there are any abnormalities, they should be replaced or repaired in a timely manner.

定期檢查電氣元件的絕緣狀態，如有損壞或老化的情況，應及時更換。

Regularly check the insulation status of electrical components, and replace them in a timely manner if there is any damage or aging.

防止電弧和漏電

Prevent arcing and leakage

電弧和漏電是低壓配電柜可能出現的隱患，需要采取相應的預防措施。具體做法如下：

Arc and leakage are potential safety hazards that may occur in low-voltage distribution cabinets, and corresponding preventive measures need to be taken. The specific approach is as follows:

定期檢查配電柜的絕緣狀態，確保無漏電現象。如有問題，應及時修復。

Regularly check the insulation status of the distribution cabinet to ensure that there is no leakage. If there are any problems, they should be repaired in a timely manner.

安裝并定期維護漏電保護器，及時發現漏電并切斷電源，確保人身。

Install and regularly maintain leakage protectors, promptly detect leakage and cut off power to ensure personal safety.

配電柜內部的高壓設備應安裝防弧罩，以防止電弧產生，確保工作的性。

The high-voltage equipment inside the distribution cabinet should be equipped with arc shields to prevent arc generation and ensure work safety.

定期校驗和測試

Regular verification and testing

低壓配電柜的準確性和可靠性需要定期校驗和測試。可以選擇每年或兩年進行一次校驗和測試。包括以下幾項：

The accuracy and reliability of low-voltage distribution cabinets require regular verification and testing. You can choose to perform calibration and testing annually or biennially. Including the following items:

校驗和測試電能表的準確性，確保電能計量的準確度。

Verify and test the accuracy of the electricity meter to ensure the accuracy of electricity metering.

測試過電壓保護器和過電流保護器的響應時間和工作效果，確保其正常工作。

Test the response time and working effect of overvoltage and overcurrent protectors to ensure their normal operation.

測試低壓配電柜的漏電電流和絕緣電阻，確保其和可靠。

Test the leakage current and insulation resistance of the low-voltage distribution cabinet to ensure its safety and reliability.